Okay, our oven has had many of the same problems others have experienced. It heats up and then the temperature falls while the display will continue to show an inaccurate temp.
I'm pretty sure the bake element is out since there is no heat whatsoever radiating from the bottom of the oven during preheat. I can see the convection ring glowing and the broil element cooked my finger. I want to check the resistance of the bake element, but am unsure how to access it.
This oven has the bake element under the oven floor. Do I need to pull the oven and access it by removing a side or am I going to have to remove the oven chamber? I cannot easily go from under the oven either since it has the lower unit with a top heat element.
We have also had F0 errors on our control panel intermittently. I would expect that it will need to be replaced too. My current intentions are to replace the ERC, Temp sensor and the bake element. I just hope I can get the bake element out without having to take the whole unit apart.
Thanks in advance.
Best,
Scott
I'm pretty sure the bake element is out since there is no heat whatsoever radiating from the bottom of the oven during preheat. I can see the convection ring glowing and the broil element cooked my finger. I want to check the resistance of the bake element, but am unsure how to access it.
This oven has the bake element under the oven floor. Do I need to pull the oven and access it by removing a side or am I going to have to remove the oven chamber? I cannot easily go from under the oven either since it has the lower unit with a top heat element.
We have also had F0 errors on our control panel intermittently. I would expect that it will need to be replaced too. My current intentions are to replace the ERC, Temp sensor and the bake element. I just hope I can get the bake element out without having to take the whole unit apart.
Thanks in advance.
Best,
Scott