Backstory: For the past 4-6 months the Start button has taken a couple of pushes to work. Over the past month... more. For a week or two I could push the Cancel button to reset (and activate drain pump). Now both Start and Cancel do not work. All other buttons work fine and can be selected and deselected.
I was able to follow instructions from another post to successfully run in "Test Mode". Every button, including Start and Cancel, lit up, blinked for several seconds and dishwasher cycled on and off for 20 minutes or so while in "Test Mode".
So, I'm looking for a second opinion. Mine is that the ribbon cable is corroded and needs to be replaced.
Does anyone have the service manual for the KitchenAid Architect Series? Or are they all the same?
TIA,
Ryan
I was able to follow instructions from another post to successfully run in "Test Mode". Every button, including Start and Cancel, lit up, blinked for several seconds and dishwasher cycled on and off for 20 minutes or so while in "Test Mode".
So, I'm looking for a second opinion. Mine is that the ribbon cable is corroded and needs to be replaced.
Does anyone have the service manual for the KitchenAid Architect Series? Or are they all the same?
TIA,
Ryan