So my dryer started acting up this weekend. My wife tried to run it and couldn't get it to start up. If I push the start button I would get a beep and what sounds like the motor bumping but not starting and running. I could do this multiple times and If I kept at it long enough eventually it would start and run. Generally it would run for anywhere between 1-5 minutes. Then it would stop running but the LED's would all still be lit up like it's still running. I would run through the same start up and eventually I would be able to get it to run again only for it to shut off within a couple of minutes. I went through all the checks from the manual inside by the drum but was unable to find anything wrong. Then tonight things got really weird. I got it to start up and in the process of pushing buttons all of the LED's on the front went off like it was off and the dryer would not stop running unless I opened the door. It did this a couple of times tonight. I'm assuming at this point it has to be the user interface board. Any thoughts would be greatly appreciated.
↧