How do I repalce the "U" shaped Metal DRIVE AUGER DISP on my GE Refrig./Freezer Icemaker.
It just screws into the motor shaft, there is no nut holding it. Do I hold the shaft of the motor with a pair of pliers and turn it by hand counter-clockwise or is there a special wrench to hold the shaft behind the auger?
It just screws into the motor shaft, there is no nut holding it. Do I hold the shaft of the motor with a pair of pliers and turn it by hand counter-clockwise or is there a special wrench to hold the shaft behind the auger?