The keypad on our Kenmore Elite Catalyst 20092 (or 110 20092 992?) went out, and I'm not paying to buy another one. The test sheet has pinouts for all of the switches, so I can replace those. I've currently wired up the regular load, start, and cancel buttons (what my wife uses 90% of the time), but I'm having a hard time tracking down the LED's circuit traces. I can't rip it apart until I build a new interface because I still need to plug it in if we lose power. It comes up with the PF signal, but I can't press any buttons, so I bring it up, disconnect the keypad, then hook up my three buttons.
Does anyone have a schematic of the keypad, or have a keypad and can figure it out better than I can?
And in addition, our dryer keypad from the same set went out 5 or 6 years ago. Model #110.60092990. I "fixed" it by bypassing the circuit board completely. When my wife wants to dry clothes, she plugs it in and sets an egg timer, and then unplugs it to turn it off. I'd like to build it another keypad too, so I'd appreciate it if anyone has it's schematic as well.
Does anyone have a schematic of the keypad, or have a keypad and can figure it out better than I can?
And in addition, our dryer keypad from the same set went out 5 or 6 years ago. Model #110.60092990. I "fixed" it by bypassing the circuit board completely. When my wife wants to dry clothes, she plugs it in and sets an egg timer, and then unplugs it to turn it off. I'd like to build it another keypad too, so I'd appreciate it if anyone has it's schematic as well.