Oven stopped heating, show (door) on display. I replaced the control board with what appeared to be exact swap, but then light stays on all time and top oven will not work. I cut the light wire which allowed bottom oven to work to get through holidays, but after operating for a little while the oven quits and (door) shows on display again. Can reset circuit breaker and bottom oven will work again for a while, usually about 45 minutes. Could control panel be issue or unit just too old and gotta replace it? We are about to put house up for sale and hate to have to buy a new oven. It did show an error when first connected new board, think it was E1F2 but stopped after I cut light wire connecting to the board. Any advice is appreciated..
↧