My wife and I have a front load kenmore.
For the last several days, we have noticed that clothes coming out of the washer felt wetter than normal as well as about 2-3 inches of standing water when we went to put a new load in. After a few test runs on an empty washer, we noted that the water does leave during the spin cycle, but when the load is finished, over time water works its way back into the load.
I've verified the hose in back is free of blockage, and I've removed the front panel to check the drain filter, no issue there.
I suspected the pump, however, when I took the outlet hose from the back and just held it out the window it definitely had water coming out of it. Hard to say if the amount out equaled the amount in, but it seemed enough to say the pump was doing its job.
any thoughts for other possible culprits?
For the last several days, we have noticed that clothes coming out of the washer felt wetter than normal as well as about 2-3 inches of standing water when we went to put a new load in. After a few test runs on an empty washer, we noted that the water does leave during the spin cycle, but when the load is finished, over time water works its way back into the load.
I've verified the hose in back is free of blockage, and I've removed the front panel to check the drain filter, no issue there.
I suspected the pump, however, when I took the outlet hose from the back and just held it out the window it definitely had water coming out of it. Hard to say if the amount out equaled the amount in, but it seemed enough to say the pump was doing its job.
any thoughts for other possible culprits?