Installed new auger motor (#2323603),still not working.Checked DC volts between the two wires that plug into motor and read 70 volts dc.Should be 120VDC.
Should I ck between one wire at a time and ground?
Can you tell me how to remove front panel on this frige to ck switches? How to remove drip tray?
The ice chute door opens and closes ok,the water dispenser works ok.
Could it be the inverter & where is it located?
Thanks in advance
John
Should I ck between one wire at a time and ground?
Can you tell me how to remove front panel on this frige to ck switches? How to remove drip tray?
The ice chute door opens and closes ok,the water dispenser works ok.
Could it be the inverter & where is it located?
Thanks in advance
John