Greetings,
My ice dispenser motor stopped working, and I've been trying to determine if it is a motor problem or a control board problem. I followed some blog advice, and checked for DC voltage across pins 1 and 2 of the connector to the motor, and got plus or minus .65 volts dc, depending on the setting of cubes or crushed. I thought that .65 volts was a very small voltage, and so I'm wondering if anyone can verify what the correct voltage should be. Thanks in advance.
Bill
My ice dispenser motor stopped working, and I've been trying to determine if it is a motor problem or a control board problem. I followed some blog advice, and checked for DC voltage across pins 1 and 2 of the connector to the motor, and got plus or minus .65 volts dc, depending on the setting of cubes or crushed. I thought that .65 volts was a very small voltage, and so I'm wondering if anyone can verify what the correct voltage should be. Thanks in advance.
Bill