This dishwasher was working. My friend bought it and it will not run.
When the power is put on, the number 2 is in the display window and what sounds like a pump runs.
Then the pump stops, Normal light is blinking, and a double dash appears in the display window.
First assumption, the folks that moved it broke a wire. I've looked and didn't find any damage.
Reviewed many problems on this blog and did some checking:
Door latch switch is OK. Closed circuit with door latched. Also checked that the latch itself was OK.
Water overflow switch is OK. Closed circuit with float in no water position.
Thermal switch on main circuit board is closed circuit.
Thermal switch on tank is closed circuit.
Heater element measures 13 ohms.
Tested line voltage on main board (white & brown leads) 123.6 VAC
The wiring schematic has been removed and lost.
The dishwasher was running the day they picked it up. My friend had to wait for the last load to be done. It has never run since.
Any suggestions on what to look for would be greatly appreciated.
Jay
When the power is put on, the number 2 is in the display window and what sounds like a pump runs.
Then the pump stops, Normal light is blinking, and a double dash appears in the display window.
First assumption, the folks that moved it broke a wire. I've looked and didn't find any damage.
Reviewed many problems on this blog and did some checking:
Door latch switch is OK. Closed circuit with door latched. Also checked that the latch itself was OK.
Water overflow switch is OK. Closed circuit with float in no water position.
Thermal switch on main circuit board is closed circuit.
Thermal switch on tank is closed circuit.
Heater element measures 13 ohms.
Tested line voltage on main board (white & brown leads) 123.6 VAC
The wiring schematic has been removed and lost.
The dishwasher was running the day they picked it up. My friend had to wait for the last load to be done. It has never run since.
Any suggestions on what to look for would be greatly appreciated.
Jay