I've been troubleshooting this Whirlpool washer for a day and a half. The fabric softener would not dispense and the bleach compartment of the dispenser tray would be full of water after a normal wash cycle. I bench tested the dispenser actuator motor and it works fine. I cleaned the dispenser drawer and the distributor holes above the dispenser drawer. With the top removed I can see the dispenser motor working and the actuator arm going to all four positions during cycles. At this time it seems that the some of the fabric softener is now dispensing, but not all of it. There was still some softener liquid left in the tray. Additionally there is still some water being left in the bleach section of the dispenser drawer. It seems that there is little to no water going through the fabric softener section of the dispenser drawer. I could use some help please?
↧