Since there is no dehumidifier sub forum, I felt this was close enough.
Frigidaire/Electolux FAD704DUD fans runs, compressor doesn't. Up to now, it's been fine.
Troubleshooting shows bypassing the compressor relay, the compressor does run.
There are two sensors; humidity & pipe temperature. Are these normally open or closed when disconnected from the circuit?
Unit is clean, no apparent problems. Circuit board looks good, no burnt components. Connectors are all tight. I'm hoping it's one of these sensors, not the board.
Frigidaire/Electolux FAD704DUD fans runs, compressor doesn't. Up to now, it's been fine.
Troubleshooting shows bypassing the compressor relay, the compressor does run.
There are two sensors; humidity & pipe temperature. Are these normally open or closed when disconnected from the circuit?
Unit is clean, no apparent problems. Circuit board looks good, no burnt components. Connectors are all tight. I'm hoping it's one of these sensors, not the board.