Maytag-type 580,Model # MVWB300WQ2, Serial # C13670925.
Symptoms have changed. Before, washer would stop @ 13 minutes remaining on drain/spin cycle, leaving water still in washer. Would sometimes complete if you kept pushing the start button.
Now, there is no water in the washer after running cycle on "NORMAL". However, I
don't know where it stopped because the "ESTIMATED TIME REMAINING"
light is flashing "Lo", the washer control knob is set on
"NORMAL" and that is flashing, and the "START" button is
flashing. When I try to change any setting or push the start button, an alarm
starts beeping, so it is not allowing me to do anything. I unplugged it, then
plugged it back in, pushed the "START" button, the "ESTIMATED
TIME REMAINING" went to "0:13", the lid lock engaged and that is
the way she remains. It might finish the complete cycle if I keep pushing the
start button, but I fear this might cause another problem.
Symptoms have changed. Before, washer would stop @ 13 minutes remaining on drain/spin cycle, leaving water still in washer. Would sometimes complete if you kept pushing the start button.
Now, there is no water in the washer after running cycle on "NORMAL". However, I
don't know where it stopped because the "ESTIMATED TIME REMAINING"
light is flashing "Lo", the washer control knob is set on
"NORMAL" and that is flashing, and the "START" button is
flashing. When I try to change any setting or push the start button, an alarm
starts beeping, so it is not allowing me to do anything. I unplugged it, then
plugged it back in, pushed the "START" button, the "ESTIMATED
TIME REMAINING" went to "0:13", the lid lock engaged and that is
the way she remains. It might finish the complete cycle if I keep pushing the
start button, but I fear this might cause another problem.