I'm trying to replace a drive belt onto the pulley, but it keeps sliding off after a few manual rotations. The pulley doesn't seem to be stationary on the shaft - there seems to be a lot of play in it. I've tried tightening the bolt that holds the pulley onto the shaft, but it won't tighten past a certain point (or enough to hold the pulley in-place better). The pulley doesn't appear bent or warped, and it seems like the shaft/bearing appears normal. It looks like there are grooves that have been gouged into the plastic wash drum where the pulley may have been grinded into it while spinning. Thanks for any advice.
↧