OK, washer was spinning slow. Replace clutch with no problems..pretty straight forward. Reconnected. Filled..now it doesnt agitate or spin. Thought perhaps I didnt plug in electric plug into motor good. Reconnected it again....however I noticed a grayish tan wire loose. It has a black female connector on the end. It appears that is wasnt a wire that pulled out of the connector. I look all over the motor and cannot find a place where this wire might go? Is this my problem? If so, where does it go? Also, I jumped the lid switch to make sure it was good....thought it might have been damaged somehow when I laid down the washer. Still no agitation or spinning. Any suggestion please...thanks!
Added note: I hear no motor noise and coupler is good.
Added note: I hear no motor noise and coupler is good.