Quantcast
Channel: Applianceblog Repair Forums
Viewing all articles
Browse latest Browse all 58835

Quiet Partner II Does not clean. Pump does not run.

$
0
0
The dishwasher runs through a cycle but the dishes are not cleaned. The soap does not even get rinsed out of the dispenser.

Does fill with water.

No codes present.

Diagnostic runs for a while then finishes. No codes.

Checked to make sure the little rubber valve by the chopper was unobstructed. All clear.

Motor windings are good.

Capacitor is good.

It does make some noise, but I think it's just the smaller pump and the water inrush...



*stopped here to go fiddle with it some more. I reconnected power from when I checked the motor windings.*

Unit comes on with all lights on.

Tried diagnostics. No dice. No code...

Now I remember a different code: I just went and pushed Sani - heat dry - sani - heat dry

It starts going through all kinds if cycles then just stops with all lights illuminated.

I tried that again and it drained then quit.

If I try and start a normal or rinse cycle now, it just hums, clicks and the soaking light comes on...


I'm beginning to think I may need a new control panel. I've been messing around with this thing and all that I've gotten out of it is that is less responsive than before...

Viewing all articles
Browse latest Browse all 58835

Trending Articles



<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>