My Duet Sport Dryer is stuck in SENSING Mode. When I Select "START" I can hear the Relays trying to connect but it does not run. Tried every Mode available. Also Unplugged the unit for 30+ Minutes to no avail.
I also know the Vent is clean. This is an older Dryer but at this time I do not have the funds for a new one.
From what I have read here (I also Downloaded the Manual). It is either the Controller Board and/or the Therm-resistor on the Output. Any Other Ideas and suggestions for the parts would be appreciated.
I am very handy and know electrical including circuit design but short on free time.
I also know the Vent is clean. This is an older Dryer but at this time I do not have the funds for a new one.
From what I have read here (I also Downloaded the Manual). It is either the Controller Board and/or the Therm-resistor on the Output. Any Other Ideas and suggestions for the parts would be appreciated.
I am very handy and know electrical including circuit design but short on free time.