My Maytag washer agitator has stopped working. When it is supposed to turn back and forth, it just spins continously.
I removed the complete agitator assembly, pumped water in the tub, and watched the shaft, it would turn back and forth like it was supposed too.
Replaced the assembly and again, it just turns in a spin.
The spline in the paddle unit is not stripped, fits on the shaft snug.
The cam dogs in the top of the agitator are fine, not worn out.
The motor coupling look fine also.
Pump works fine, spins OK.
The little pads on the inside of the paddle assembly, at the very bottom, were damaged like they were rubbing something rough.
Someone have any ideas that a I could check to fix this unit?
I removed the complete agitator assembly, pumped water in the tub, and watched the shaft, it would turn back and forth like it was supposed too.
Replaced the assembly and again, it just turns in a spin.
The spline in the paddle unit is not stripped, fits on the shaft snug.
The cam dogs in the top of the agitator are fine, not worn out.
The motor coupling look fine also.
Pump works fine, spins OK.
The little pads on the inside of the paddle assembly, at the very bottom, were damaged like they were rubbing something rough.
Someone have any ideas that a I could check to fix this unit?