Brand new GE dishwasher installed last week and ran a cycle. Cleans fine and completes the cycle by draining completely, but once drained, inlet valve opens and bottom of the dishwasher fills with fresh water. Thought I was chasing a drain problem, but the unit drains fine.
Once drained, the water flow starts. I confirmed the water is form the inlet because I shut the valve under the sink off immediately after the unit drained and the unit did not refill. I waited a few minutes and then opened the valve under the sink and the unit immediately began to refill.
Unit is brand new - go figure. Is it the inlet valve? Maybe faulty?
Thanks in advance.
Cameron
Once drained, the water flow starts. I confirmed the water is form the inlet because I shut the valve under the sink off immediately after the unit drained and the unit did not refill. I waited a few minutes and then opened the valve under the sink and the unit immediately began to refill.
Unit is brand new - go figure. Is it the inlet valve? Maybe faulty?
Thanks in advance.
Cameron