PFS22SISBSS Recall warranty
I cant find too much info on this model about the recall or lawsuit. However is this model still eligable for the warranty replacement of the Motherboard, ect?
View ArticleClik here to view.
Frig & freezer no longer cool very well
I have an older Maytag frig that suddenly doesn't cool very well - frig section & freezer. I first noticed what I thought was a noisy defrost timer. I removed it and the leads tested OK...
View ArticleNorcold fridge doing on-off, on-off routine
Hi, all - I have a Norcold fridge on my boat that's suddenly doing an on-off thing, running for about 2 seconds, off for about 4, then over again. The basic question is whether or not this condition...
View ArticleLow water level.
Hi all. I have a top load Whirlpool Cabrio washing machine. About 3 month ago the wash plate stopped working (stripped the plastic sleeve) I order a new one and was back up running UNTIL yesterday its...
View ArticleKenmore Icemaker not filling with water
Orignal Ice maker (Model: RIM Hi-Start) stopped making ice. Last year, the LED boards were showing signs of going bad (never going steady), so I removed and reinstalled them and magically started to...
View ArticleGSS25KGMCBB freezer and fridge room temp.
about 6 months ago i had a defrost problem, so i replaced the defrost thermostat,temp sensor, and the defrost heater assembly. fridge and freezer worked great till a few days ago. i noticed the kitchen...
View Articlemaytag performa LAT2500AAE will not drain or spin
Washer was working fine. Then lid switch went out. Replaced the lid switch and started working again. Shortly after stopped draining and will not spin on any mode. Jumped the switch and still not...
View ArticleMaytag A608 not draining
Have a Maytag #A608 not draining after its cycle. Timer is ticking.So wondering what to check first.Timer motor, or pump or something else? Also anybody have the manual for this antique? :)
View ArticleLSQ9010LW0 Spin Cycle Banging After Replacement Parts
Have a loud banging noise and whirring noise during spin cycle. Replaced brake shoes, clutch assembly, all suspension springs, drive coupling. No change. Sounds like it is likely to be transmission but...
View ArticleGE Washer problem
This machine is about 25 years old. There seems to be a problem with the soap being rinsed from the clothes. When I open the lid during the rinse cycle the water is very soapy and at the end of the...
View ArticleGE GDF510PGD1BB Drains but Refills
Brand new GE dishwasher installed last week and ran a cycle. Cleans fine and completes the cycle by draining completely, but once drained, inlet valve opens and bottom of the dishwasher fills with...
View ArticleFIXED kenmore elite gas dryer problem
wife using dryer yesterday dryer stoped no led lights nothing have 120 at plug. i am a hvac tech but may need some help not checked anything other than power yet thanks dale
View ArticleKenmore 700 series cycle select knob
Purchased a Kenmore 700 series electric dryer in Jan of 2009. It didn't take long, maybe 2 years, before the cycle select knob became stripped and we couldn't use it anymore. We then used a wrench for...
View ArticleWater dispenser problem
If I remove the water filter and put the cover back on I get water flow and it dispenses from the door....for a period of time...about 3 or 4 glasses and then it stops. If I remove and replace the...
View ArticleFrigidaire side/side
Changed out control board for defrost control circuit and now damper motor will not operate correctly. Had to change wiring harness for new control to plug into. New harness has only one connection for...
View ArticleWhirlpool microwave not heating and smells like burning wires
I have a Whirlpool Microwave model MH6150XHQ-1 that turns on, but is making a buzzing sound, & smells like wires are burning up. Any ideas, or suggestions.
View ArticleRefrigerator Part of Side by Side does not Cool
The refrigerator only cools to 48F even though I have set the temperature to 34F.:confused:
View ArticleLower ice maker adjustment
My lower ice maker is clumping ice in the tray. Seems to be a water level issue. Is there a ajustmentfor water level?
View ArticleKenmore Dishwasher dead
Hello, I have a Kenmore dishwasher approx 2.5 years old. Model# 665.13213K901 Serial#F03819664 This am I noticed the dishes were still wet. I tried to restart it thinking someone had hit the off switch...
View ArticleWhirlpool Washer Not Progressing Properly
Hello, I have a Whirlpool Top-Loading washer (WTW4950XW2) that's less than 2 years old. For the past couple of months the washer has not been progressing properly through the cycles. Sometimes it will...
View Article