Hi,
So yesterday I performed the basket clean function on my washer, twice to make sure the javex was all gone. I then found during the second basket clean there was no water in the in the basket. Thought nothing of it, cleaned out the filter and walked away.
Today whenever I try to do a wash the pump just starts running and the cycle will not start.
Things I have done:
I also notice it counts down in the cycle while it is pumping put eventually stops and the start/pause button flashes.
I am stumped and don't no where to turn.
Glen
So yesterday I performed the basket clean function on my washer, twice to make sure the javex was all gone. I then found during the second basket clean there was no water in the in the basket. Thought nothing of it, cleaned out the filter and walked away.
Today whenever I try to do a wash the pump just starts running and the cycle will not start.
Things I have done:
- measured resistance of all water intake solenoids and they measure 1K
- checked pump was clear and it is
- checked resistance of pump, 11ohms
- when through the maintenance codes and found an error 30, cleared it and completed all the other tests and they worked.
- did not unplug while in maintenance mode
- return to normal and tried to perform basket clean and washer just pumps
- go back to maintenance mode and no error
I also notice it counts down in the cycle while it is pumping put eventually stops and the start/pause button flashes.
I am stumped and don't no where to turn.
Glen