Somewhere on here, I saw some posts about premature drain cycles, which mostly pointed to the soil pressure sensor. The soil pressure sensor, which is small, sits between a hose and the pump. I removed the sensor and it looked very clean (like new). I put the sensor back in and still had the same problem. I then disconnected the two wires from the soil pressure sensor and still had the same problem. I pulled the tech sheet out from under the dishwasher, but there was no mention about troubleshotting the sensor. The tech set mentions about running a diagnostics cycle both for when the dishwasher is running and not running. Would the diagnostics pick up the problem? What other system tests or electrical checks can I run to try and pinpoint the problem? The only other reference I saw for this problem was the control module.
↧