The problem started with no high spin during spin/drain cycle. During the spin/drain cycle, everything would be normal until the timer would reached 6. At that time display and all lights would go out. No error code would display.
I found that the motor had hit the motor speed control and cut a yellow wire. I solder the wire back together. Try cycle again, problem remained.
I went through the diagnostic cycle. High speed spin was OK. Showed error E47. Cleared code, tried cycle again, problem remained.
Door lock works. I did check with a meter also, 1324 Ohms.
As suggested by the manual, I replaced the control board. The board I removed was 134345500, which has been discontinued. Supplier showed a replacement as 137006000, according to my model number. The new board does not have the J8 pins for the detergent door. I am guessing this is the issue?
Any ideas?
I found that the motor had hit the motor speed control and cut a yellow wire. I solder the wire back together. Try cycle again, problem remained.
I went through the diagnostic cycle. High speed spin was OK. Showed error E47. Cleared code, tried cycle again, problem remained.
Door lock works. I did check with a meter also, 1324 Ohms.
As suggested by the manual, I replaced the control board. The board I removed was 134345500, which has been discontinued. Supplier showed a replacement as 137006000, according to my model number. The new board does not have the J8 pins for the detergent door. I am guessing this is the issue?
Any ideas?