if I unplug the power to the washer over night then plug it back in, set the dial to normal/casual it will complete the first cycle of washing with out a problem, but if I try to do another load the machince will stop on the rinse cycle and the add a garment, rinse and clothes clean error code flashes (long drain) and the machine stops. If I unplug the power for 1/2 hr minimum and then plug it in again, then set the dial to express wash, it will some times complete that cycle. If I set the dial to normal wash it will not complete unless I unplug power over night. I have run the service history and diagnostic test according to the manual, many times and it always completes succesfully without any errors. I have checked the lint trap, the pump motor, the tub to lint trap hose, the drain hose and all are clear of any obstructions. The drain pump was replaced with a new one in nov of 2012. I am wondering if the ccu board is over heating and by unplugging power for a long tome it cools and operates once, correctly. only once did another error code appear (add a garment, controls locked) pump drive system error.
↧