So it all began with a problem with the fill valve. It was letting water drip continuously into the ice tray. With the continuous drip, the ice on the right side of the tray had no chance to freeze...water spills down side and freezes...big mess. Got everything cleaned up, removed ice maker and cleared the overabundance of ice in it. Replace fill valve. Put ice maker back in but nothing happened. Jumped the module to start a cycle and everything went smoothly. Water filled, ice froze, but then it sat in the tray for several hours. Pulled out tray and started process all over again. This time the ice dumped but only one time. Sat overnight with another batch in the tray. Went through process again and this time go maybe 2 loads dumped over a 10 hour period. The ice seems to be filling and freezing in very little time, but the sweeper doesn't do it's job.
The LED light is off and has been since (at least I've noticed it off) I started messing with the ice maker.
Any ideas on this intermittent problem? Guessing I should be getting at least 1 dump and hour...probably more like 2.
Thanks...and thank you for this forum. It helped quite a lot with my repairs.
Mike
The LED light is off and has been since (at least I've noticed it off) I started messing with the ice maker.
Any ideas on this intermittent problem? Guessing I should be getting at least 1 dump and hour...probably more like 2.
Thanks...and thank you for this forum. It helped quite a lot with my repairs.
Mike